$3,500 – Middleton, WI:
“Selling my 1987 Chrysler Conquest. No rust. It is basically a race car. Clean Title. Runs strong and pulls hard. I’m moving to California and can’t take it with me so my loss is your gain. There’s been a ton of money put into this car.
The ridiculous exhaust coming out of the hood is no longer present. I put a much shorter Stainless pipe in its place.
Parts list:
Lets start with the engine (rebuilt at some point before I owned the car)
What has been done to it since I owned:
Built Non Jet Head ~ 500 miles on it
Ajusa Metal Head Gasket
ARP Head Studs
+1mm oversized Stainless Steel Valves intake and exhaust
Ported/ gasket matched intake and exhaust
Schneider Racing valve springs
Newer turbo manifold
EVO 3 16G TURBO (no shaft play)
Tial BOV
Big filter cold air intake
Rebuilt Throttle Body
No fuel-cut ECU
Stage 4 6 puck Clutch
Fidanza Lightweight Flywheel
AEM UEGO WidebandSuspension:
D2 Coilovers
Upgraded Sway bars front and rearInterior:
Fully gutted and caged
ISR Hydro E-Brake
5 Point racing harness for both passenger and driver
Corbeau Racing drivers seat
OMP Steering Wheel
Ralli Art Shift Knob
Glow Shift boost gauge in original in-dash location
A/C delete
Heat deleted (this car is about as light as you can get it. I’m not sure exact weight but I guess ~2600 lbs.)Exterior:
Not much done here besides the blue paint/ black hood
some dents and scratches but nothing serious
Mounting point for a spoiler/ wing on rear hatch
Hood Stack Exhaust (only way I could route the exhaust from the turbo without doing a full custom exhaust)”
Source: https://madison.craigslist.org/cto/d/1987-chrysler-conquest/6408522403.html
