$2,500 – Clifton, NJ:
“1995 d21 hardbody
I’ve had this project for a few years and i honestly don’t want to let it go but other priorities have come up and I have no choice. My loss is your gain. Everything is listed below. Price is 2500 obo. I’ve got probably double if not more than that in price for truck and all the parts and custom work done to it.
Truck will need to be towed. It does run and drive, but it is not insured and i will not test drive it in the street. I can move it back and forth in the drive way.
Engine
– stock with 160xxx miles
– new ngk sprak plug wires
– new ngk spark plugs
– egr delete
– new oil pump and gaskets
– new front engine cover gaskets
– new water pump
– new timing chain kit which included new guides (installed already)
– stock headers
– deleted vacuum lines( unnecessary ones)
– custom koyo radiator
– custom 12 gallon fuel cell with 70-10 ohms sending unit
– atx-e2000 external fuel pump
– new injector gaskets/grommets
– new oem engine mountsTrans
– 5-speed trans from 240sx s13
– ISR short throw shifter
– new LUK clutch, flywheel and throwout bearing
– 240sx speed sensor
– new ISR trans mount
note: i bought the trans used and found out later that its not in the best condition. The shifter pops out of gear sometimes and it sometimes grinds when going in gear. I would recommend getting another trans. Guys sell 240sx trans all the time and are very easy to source. **the driveshaft will need to be shortened about 1″ as I found out while driving that it rubs a little.Body/Suspension
– custom frame for the rear end
– 240sx rear subframe installed
– custom rear strut towers
– used KYB AGX rear shocks with EIBACK lowering springs
– custom rear bumper
– custom led rear lights
– custom wooden flatbed ( i have all the pieces cut just did not have them all installed in the pics)
– custom fuel lines ( stainless steel and hard lines)
– custom rear brake lines (hard lines)
– new rear pads ( i have new front pads not installed yet)
– New rear rotors
– Extended rear lug bolts
– Custom mount for the fuel cell
– new front bumper (not installed yet)
– HID headlights (they are not the sealed ones so the bulbs can be replaced)
– hood pins installed ( latch started to give)
– alignment was done about 2 months ago. drives straight.
– the cab mounts are a little loose.
– new side mirrors
– new passenger side upper ball joint
– Vibrant Performance Ultra quiet muffler
– Godspeed adjustable rear arms
note: the front half of the frame does have rust spots. I was planning to fix them however just did not get to it. I do have the metal to fix it which i can throw in. The plan was to eventually swap the 240sx front subframe as well and address the rust issues in the front then. The front right now is 6-lug (stock) and the rear is 5-lug. I will be giving the 2 sets of rims with the different lug pattern. I have both seats for the truck; passenger seat is currently out.Truck will come with everything listed above as well as:
– 240sx s13 front subframe ( loaded with everything on it)
– 240sx s13 front struts (KYB AGX with EIBACK lowering springs)
– (4) 6-lug 15″ rims (with tires but they are not in best shape)
– (2) 6-lug 14″ rims (with tires but they are not in best shape)
– (4) 5-lug 15″ rims (with tires in decent shape// 2 are on the truck now)
– new kyb oem front shocks (for the truck to replace old ones until the 240sx front subframe swap is done)
note: there might be things that i am forgetting but anything i have related to the truck i will throw in.===
1995 Nissan hardbody
cylinders: 4 cylinders
drive: rwd
fuel: gas
paint color: black
title status: clean
transmission: manual”
Source: https://newjersey.craigslist.org/cto/d/1995-nissan-hardbody-d21/6707578222.html
